Before Starting - Stihl FSB-KM Manual De Instrucciones

!
Warning!
Always shut off the engine and make
sure the cutting attachment has stopped
before putting a trimmer down. When
transporting it in a vehicle, properly
secure it to prevent turnover, fuel
spillage and damage to the unit.
Fuel
Your STIHL power tool uses an oil-
gasoline mixture for fuel. For further
instructions see the safety precautions
and the chapter on „Fuel" of the
instruction manual of the KombiEngine.
!
Warning!
Gasoline is an extremely
flammable fuel. If spilled
and ignited by a spark or
other ignition source, it
can cause fire and serious
burn injury or property
damage. Use extreme caution when
handling gasoline or fuel mix. Do not
smoke or bring any fire or flame near the
fuel or the power tool. Note that
combustible fuel vapor may escape from
the fuel system.
FSB-KM

Before Starting

!
Warning!
Always check your power tool for proper
condition and operation before starting,
particularly the throttle trigger, throttle
trigger interlock, stop switch, cutting
attachment and deflector. The throttle
trigger must move freely and always
spring back to the idle position. Never
attempt to modify the controls or safety
devices. Never use a power tool that is
damaged or not properly maintained.
!
Warning!
Do not attach any cutting attachment to
a unit without proper installation of all
required parts. Failure to use the proper
parts may cause the head to fly off and
seriously injure the operator or
bystanders.
!
Warning!
The cutting attachment must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.). Replace damaged heads
before using the power tool.
English / USA
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, grease
or resin in order for you to maintain a firm
grip and properly control your power
tool.
!
Warning!
To reduce the risk
of personal injury
to the operator
from blade or line
contact and
thrown objects, make sure your unit is
equipped with the proper deflector,
handle and harness for the type of
cutting attachment being used (see
chart in the chapter on "Approved
Combinations of Cutting Attachment,
Deflector, Handle and Harness").
Keep the deflector adjusted properly at
all times (see chapters on "Mounting the
Deflector" and "Mounting the Cutting
Attachments" of your instruction
manual).
7