Manual mode
The pump remains permanently switched
on if the float switch is set vertically (cable
hanging down).
N O T E
The pump can run dry in manual mode.
• Switch off the pump when the minimum
water level is reached.
• Running the pump dry increases wear.
Installing the pump
D
• Install the pump in a vertical and stable
position in the water.
• If it needs to be lowered into a shaft, fas-
ten a rope to the handle. Do not carry it
by the mains power cable.
• Install the pump such that it does not
take in dirt particles with a size >40 mm,
which would block the intake. Install the
pump in a raised position if necessary.
• Ensure that the float switch can always
move freely.
14
OPERATION
W A R N I N G
Dangerous electrical voltage!
Death or severe injury from electrocu-
tion.
• Only connect the pump to the power
supply when there are no persons in or
reaching into the water.
• Before stepping into or reaching into the
water, switch off all units located in the
water.
Switching on the unit
• Insert the power plug into the socket.
– The pump is ready for operation.
– The pump will start up as soon as the
level of the water reaches the switch-
on height.
Switching off the unit
• Disconnect the power plug.
– When the pump is switched off, resid-
ual water in the hose may flow back
and out of the pump intake.
N O T E
Do not use the unit for long-term opera-
tion. Otherwise this will impair the operat-
ing life of the unit accordingly.
N O T E
Rinse out the pump with clean water after
use.
ProMax MudDrain 25000/30000