Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Setting up the Window Mount
Parts
Back
Support
Recommended Tools and Materials (Not Provided)
Phillips screwdriver
Assembling the Mount
1.
Align the hole in the clip with the press nut at the top of
the the back support. The hole in the clip should fit around
the raised lip of the press nut.
2.
Insert a 10-32 x 1/4" screw through the aligned holes in
the clip and back support, and tighten.
Setting up the Window Mount
10-32 x 1/2" Screw
Clip
10-32 x 1/4" Screw
Rubber Bumper (2)
Exterior Bracket (2)
Window Mount Base
Rubber Washer
5/16" drive
3.
Push the two rubber bumpers through the two holes in
the bottom of the back support.
Make sure the rubber bumpers are fully installed before
proceeding, as these will prevent the mount from
scratching the vehicle.
Mounting Screw (8)
3" x 3" Film Plastic (2)
(not shown)
Rubber Foot (4)*
Foot Screw (4)*
*Included with antenna unit.
Page 2
Publicidad
Tabla de contenido
