Winegard MT-SM30 Manual De Ensamblaje, Instalación Y Funcionamiento página 6

Hanging the Window Mount
Model MT-SM30 window mount should only be used when the vehicle is stationary. Do not deploy the window mount
while the vehicle is in motion. Remove prior to traveling.
Do not walk under the window mount assembly when deployed.
Once ready to use the antenna, hang the window mount assembly on the window or exterior bracket.
• If hanging the assembly on the vehicle window, apply the
plastic film where the mount will be hung on the window,
and then slide the clip over the plastic film. The window
may need to remain slightly open when the window
mount is on the window.
The window mount should be carefully hung when
attaching to the window, or the window may be damaged.
Care should be taken when using the window mount in
inclement weather.
Routing and Connecting Cables
1. Make sure a coax cable is connected from the "Satellite
In" port of the primary receiver to the MAIN port on the
antenna. If connecting the antenna to two receivers, make
sure a second coax cable is connected to the SEC port.
2. Hand-tighten coax connections, and then tighten a quarter
turn more with a 7/16" wrench. Do not overtighten.
3. If there is a power socket on the antenna base, verify the
power cable has been connected to the power socket on
the base. Refer to the antenna manual if unsure how to
connect the power cable. Also, verify the opposite end of
the power cable is connected to a 12V power source.
Before Traveling
Model MT-SM30 window mount is intended for stationary use only and must be removed prior to traveling. Do not
deploy the window mount while the vehicle is in motion.
1. Turn off power to the receiver.
2. Disconnect the power cable from the antenna, and
disconnect coax cables from the MAIN and SEC ports of
the antenna.
Page 5
• If hanging the assembly on the exterior bracket, make sure
the sealant is dry, and slide the clip into the exterior
bracket. When placing the antenna on the optional
exterior bracket, ensure that the window mount is
properly secured to the optional exterior bracket; failure
to secure properly may result in injury.
When placing the antenna on the optional exterior
bracket, ensure that the window mount is properly
secured to the optional exterior bracket; failure to
secure properly may result in injury.
Carryout G2 antenna
(with power socket)
3. Carefully remove the antenna and window mount
assembly from the window or exterior bracket.
4. Store the antenna and window mount assembly and
cables inside the vehicle while traveling.
Setting up the Window Mount
Pathway X1 antenna
(without power socket)
• Before Traveling