Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.
To complete the installation, position the flat side of two
rubber feet against the holes on the bottom of the window
mount base, and install two screws through the aligned
holes in the rubber feet, window mount base, and antenna
base. Tighten to 40 in*lbs.
7.
For stability, position the flat side of the remaining two
rubber feet against the raised feet holes, and install two
screws through the aligned holes in the rubber feet and
antenna base.
Only hang the window mount assembly on the
window when the vehicle is parked and the antenna is
in use; store the window mount assembly when not in
use. Model MT-SM30 window mount should only be
deployed when the vehicle is stationary. Do not use
while the vehicle is moving. Remove prior to traveling.
Installation of Exterior Brackets
After the antenna has been secured to the mount, the assembly can be hung on the edge of a window or on the provided
exterior brackets. The exterior brackets will enable the assembly to be hung on the exterior of the vehicle. Complete the
following steps to install the exterior brackets on the vehicle.
1.
Choose a location on the exterior of the vehicle for the
exterior brackets. Consider possible obstructions to the
satellite line-of-sight and where cables will be run.
Consult with the vehicle manufacturer to determine
the best location for the exterior brackets, keeping
in mind the location of wires and other internal
components.
2.
Clean the areas where the exterior brackets will be
installed on the vehicle.
3.
Position an exterior bracket over one of the chosen
locations for installation, making sure that the top of the
exterior bracket is oriented upwards (see image to right for
reference). Keep in mind that the antenna assembly should
be level front-to-back and side-to-side for best operation.
4.
Trace around the edge of the bracket, and mark pilot holes
through the bracket.
5.
Drill the pilot holes.
6.
Apply sealant in the traced area.
Setting up the Window Mount
7.
Mount the exterior bracket with four of the provided
mounting screws.
8.
Apply sealant over the screws.
9.
Repeat steps 3–8 for the second exterior bracket.
Only hang the window mount assembly on an exterior
bracket when the vehicle is parked and the antenna is
in use; store the window mount assembly when not in
use. Model MT-SM30 window mount should only be
deployed when the vehicle is stationary. Do not use
while the vehicle is moving. Remove prior to traveling.
Top
Bottom
Page 4
Publicidad
Tabla de contenido
