Install Remote Control Batteries; Battery Installation; Precautions Concerning Batteries; Basic Operation - Soundstream H-500Di Manual De Instrucciones

Install Remote Control Batteries

The provided Remote Control allows the unit to
be operated from a distance.
When operating the Remote Control, point it
towards the remote sensor on the front panel of
the unit.
Even if the Remote Control is operated within

the effective range (5m), remote control
operation may be impossible if there are any
obstacles between the unit and the remote
control.
If the Remote Control is operated near other

products which generate infrared rays, or if other
remote control devices using infrared rays
are used near the unit, it may operate incorrectly.
Conversely, the other products may operate
incorrectly.

Battery Installation

1
Remove the battery compartment cover.
2
Insert two "AAA" (R03 or UM-4) dry batteries.
Make sure that the batteries are inserted
with their positive ""±and negative ""±poles
positioned correctly.
3
Close the cover.

Precautions Concerning Batteries

Be sure to insert the batteries with correct

positive "" and negative "" polarities.
Use batteries of the same type. Never use

different types of batteries together.
Either rechargeable or non-rechargeable

batteries can be used. Refer to the precautions
on their labels.
When the Remote Control is not to be used for a

long time (more than a month), remove the
battery from the Remote Control to prevent it
from leaking.
If the batteries leak, wipe away the leakage

inside the battery compartment and replace the
batteries with new ones.
Do not use any batteries other than those

specified. Do not mix new batteries with old
ones.
Do not heat or disassemble batteries. Never

throw them in fire or water.
Do not carry or store batteries with other metallic

objects. Doing so could cause batteries to short
circuit, leak or explode.
Never recharge a battery unless it is confirmed

to be a rechargeable type.

Basic Operation

Power

You can use all the functions on the panel of the
unit or the remote control after connecting to power
supply (called Standby Mode).
Turning the System On
Press the button to turn the system on from
standby mode.
Note:
When turning the system on, the system will
continue in the mode it was in when it was
turned off last time.
Turning the System Off
Press the button again to turn the system off
and go to standby mode.
Note:
Be sure to unplug the power cord from the outlet
when the system is not in use for an extended
period of time.

Select the Correct TV System

Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TV in your country.
1
No disc mode, press the SETUP button.
2
Select [Preference Page].
3
Select [TV Type] and then press the
4
Select a setting and then press the ENTER
button.
- [PAL] - For TV with PAL color system.
- [Auto] - For TV that is compatible with both
NTSC and PAL (multi-system).
- [NTSC] - For TV with NTSC color system.
5
To exit the menu, press the SETUP button.

Change System Menu Language

1
Press the SETUP button.
2
Select [General Setup Page].
3
Select [OSD language] and then press the
button.
4
Select a setting and then press the ENTER
button.
5
To exit the menu, press the SETUP button .
9
button.

