Set The Clock; Adjust Volume Level; Select A Preset Sound Effect; Super Bass Boost - Soundstream H-500Di Manual De Instrucciones

Set the Clock

The built-in clock shows the correct time in the
display.
1
In standby mode, press and hold the CLOCK
button to activate the clock setting mode, hour
indicator will blink.
2
Set the hour with the
3
Press the ENTER or CLOCK button to confirm,
minute indicator will blink.
4
Set the minute with the
5
Press the ENTER or CLOCK button to confirm,
the built-in clock starts operating and the
seconds start counting from 0.
Note:
* The operating time of every step shouldn't be
longer than 15 seconds or it will return to the
original display.
* If there is a power failure or the power system is
turned off, the clock will lose its setting.
* In standby mode, press and hold the CLOCK
button for a few seconds, then press the BF
button to select 12/24 hour format.
To confirm the clock time
When you press the CLOCK button, the clock time
is displayed. Wait for a few seconds until the display
returns to the original display.

Adjust Volume Level

During play, press the VOL+/- buttons to
increase/decrease the volume level.

Select a Preset Sound Effect

During play, press the EQ button repeatedly to
select:
- [POP]
- [CLASSIC]
- [ROCK]
- [JAZZ]
- [FLAT]

Super Bass Boost

Press the BASS button repeatedly to select the
bass boost level.

Mute Sound

During play, press the MUTE
or restore sound. Press this button again or
VOLUME+ button to cancel the effect.
button or button.
 
button or button.
 
button to mute

Adjust Brightness of Display Panel

Press the DIM button repeatedly to select
different levels of brightness for the display
panel.
Program Smart Remote Control to
Control TV
You can store a total of 7 most frequently used func-
tion of you TV in the learning zone of smart remote
control. This feature allows you to use only one re-
mote control to operate all of your TVs.
By default, the remote control codes of a TV are
stored in the smart remote control. The available
preset buttons are Standby,
ENTER, TV VOL+/VOL-, TV CH+/CH-.
NOTE:
During the learning process, the normal remote
control functions are disabled.
1 Place the smart remote control (A) within 5mm-
50mm distance from the TV remote control (B).
2 Press and hold LEARN button for 2 seconds to
activate the learning mode. A red indicator on
the smart remote control (A) lights up.
3 Press one of the TV (learning zone) buttons
on the smart remote control (A), the red
indicator flashes.
4 Press the button on TV remote control (B) that
is to be stored on the smart remote control (A).
When the code is received successfully,
the red indicator flashes 3 imes, then turns red
again. If the red indicator flashes but does not
turn red, code received is not successfully.
5 Repeat steps 3-4 to program more buttons on
the smart remote control (A).
6 Press LEARN to save the learning and then to
exit the learning mode.
10
(FUNCTION),