Menu Configuration - ARVA NEO+ Guía De Utilización

DYNAMIC INTERFERENCE
MANAGEMENT
Beacon users are carrying more and more electronic
devices that can cause interference during the primary
search.
This has been observed in mountain resorts and in rare
cases in backcountry. You can activate in the menu a
specific mode that prevents the device from additional
electronic noise by reducing the search band, depending
on the level of interference there are three selections.
• The search band in normal environment is 70m => the
device will display SR 70 when you switch to search.
• If the interference is at a minimum level select SR 30=>
device will reduce the search band to 30m.
• If the interference is at a maximum level select SR 15
=> device will reduce the search band to 15 m.
• Pay attention, use good judgment, and adapt your
search scenario to the best option for your needs.

MENU CONFIGURATION

(Experienced users)
With the beacon switched off, go into the search mode by
sliding search button up. Turn beacon on while holding
the center button until the batteries status. The only
button used to managethe menu is the central one.
Select with a long push, chose
option with shorts pushes
0= No auto-revert
2/4/8= select between
2/4/8 minutes
long
short push push
Select with a long push, chose
option with shorts pushes
3= marking below 3 m of the
victim
5= marking below 5 m of the
long
victim < 5 m
short push push
Select with a long push, chose
option with shorts pushes
0= group check OFF
1= group check ON
long
short push push
Select with a long push, chose
option with shorts pushes
0= Interference mode OFF
1= Interference mode ON
long
short push push
long
push
EN
OK
long
push
OK
long
push
OK
long
push
OK
long
push
OK
end
long
push