Makita DCF203 Manual De Instrucciones página 9

To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
► Fig.2: 1. Red indicator 2. Button 3. Battery cartridge
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the appliance, causing
injury to you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
If it is hard to slide the battery cartridge out, push it from
the backside while sliding the button on the front of the
cartridge.
► Fig.3
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.4: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Adjusting fan head angle
The angle of the fan head can be adjusted manually. The adjustable range of the fan head is as shown in the figure.
► Fig.6
NOTICE:
Do not turn the fan head beyond the adjustable range.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to the motor
to extend appliance and battery life. The appliance will
automatically stop during operation if the appliance or
battery is placed under one of the following conditions.
• Overload protection : When the appliance is
operated in a manner that causes it to draw an
abnormally high current, the appliance automati-
cally stops without any indication. In this situation,
turn the appliance off and stop the application
that caused the appliance to become overloaded.
Then turn the appliance on to restart.
• Overheat protection : When the appliance is over-
heated, the appliance automatically stops. Let the
appliance cool down before turning it on again.
• Overdischarge protection : When the battery
capacity becomes low, the appliance stops auto-
matically. If the appliance does not operate even
when the switches are operated, remove the
battery cartridge from the appliance and charge it.
OPERATION
Starting / stopping the fan
Press the power switch button to turn on the fan. Press
the power switch button again to turn off the fan.
Changing wind speed
Press the wind speed change button while the fan is
running. The wind speed increases every time you
press the button. The wind speed will return to the
lowest speed when running in the highest speed. The
cordless fan will start in the same speed as the previous
setting.
► Fig.5: 1. Wind speed change button
9 ENGLISH