SWM SILVER VASE 440 Guía Rápida página 50

INSTRUCTIONS FOR USING THE MOTORCYCLE
STARTING THE ENGINE
After getting on the motorcycle as described in the
relative paragraph, operate as follows to start the
engine:
1) raise the side stand;
2) Place ignition key (1) to position (the buzz
that you hear when you turn the key to
caused by the fuel pump which puts the feeding
system under pressure);
3) pull the clutch lever (2);
4) shift gear pedal (3) to neutral position then re-
lease the clutch control level;
5) check that the button (4) is in
then press the start button (5).
When a cold engine has just been started, do not
increase revs, to ensure an adequate oil warm-
up and circulation.
Note*: A safety switch is set on the clutch lever
support. This switch allows you to ONLY start the
engine with the gearbox idle, or with the gear en-
gaged and the clutch lever pulled.
5
EN - 14
SILVER VASE 440 / GRAN TURISMO 440
is
position and
4
N
3
1
2
N
GRAN MILANO 440
1
3
2