External Connections - AVS Electronics XSATHP Manual Del Usaurio

Optional Supplying Section - PW3 - PW5
PW3 - The supply unit is switching 50W with tension in output of 14,5 V and max current of 3.4 A
PW5 - the supply unit is switching 75 W with tension in output of 14,5 V and max current of 5.1 A
The satellite can distribute the currents in intelligent way among various devices, managing both
recharge of internal battery and siren battery in dynamic way.
Chart of reference supplying XSATHP
Mains supplying
Tension
Max. current consumed by the mains
Max current available
Max current avai lable (RS485 - 2) -
(RS485 3)- (RS485 - 3) - (VLINEE)
Excluded board consumption (250 mA)
Max current available
Output tension at 110-230V~ -10%
Output tension at 110-230V~ +10%

External Connections

Insert a multi-pole mains switch having the min distance of at least 3mm between the contacts in the
electrical installation of the building. Place a ring terminal on the ground wire and fix it to the threaded
pin marked by the ground reference. The satellite board is connected to the ground via the metal
pins of the housing .
For the input of the electrical mains supplying, use double-isolated cables.
System activation without presence of electrical mains
- connect the battery to the satellite
- make a jumper on S3 as pulsed
- the satellite will only work until reaching a minimum threshold of tension, and afterwards the
supplying will deactivate.
The programmed interruption of the supplying is very useful in case of long mains absence and
batteries completely discharge; in this context all peripherals will be detached avoiding situations of
flowing supplying.
Supply Unit
+V -V
100-240V (+/-10%) 50/60 Hz
Nominal tension of supplying
PW3: 1.3 A/115V~ / 0.8 A/230V~
PW5: 2A/115V~ / 1.2A/230V~
PW5 supply unit
Outputs with PW5
Outputs with PW3
Outputs with PW5
BATTERY RECHARGE output
(size up to 17 Ah batteries)
Empty
At max charge
Empty
At max charge
The supply unit must be connected as follows:
(L) Phase 230V~
(N) Neutral 230V~
N L
Ground terminal
(V-) Negative output 14.5 V
(V+) Positive output 14.5 V
(VADJ) Trimmer of voltage adjustment - Do not modify
- Fix the supply unit to the satellite housing using the
screws given within before placing the panel to the wall
without tightening too strong , so as to be able to take
away the supply unit afterwards.
- Fix the cable shield 230 V with the special band. Connect
the ground terminal of the supply unit to the satellite
housing by use of the special pin.
!!! USE THE SCREWS GIVEN WITHIN!!!
- 27 -
da 13,5 V a 14,5 V
3.4A
5.1A
2.75 Ah
3.8 Ah
600mA
13,8 V
13,6 V
13,8 V
13,6 V
E
N
G