AVS Electronics XSATHP Manual Del Usaurio página 36

Connection Scheme of XSATHP in UNIVERSAL mode
This option allows to connect the peripherals/detectors to any kind of control panel, by using the
serial connection RS485 to the XSATHP satellite.
The satellite has 8 transistorized outputs available + 8 with optional module (mod. XOC8).
It is possible to manage 16 peripherals connected in RS485.
3 inputs are available to connect traditional detectors directly to the terminal board (L1 - L2 - L3);
shouldn't they be used, they must be balanced with 4.700 ohm resistances.
Example of connection of BM...HP beams
E
Note: the EMITTER must always be connected in traditional mode, the receiver only is managed
via RS485.
N
G
F3.15A
Max 16 RX connected in RS485 in //
OC 1 2 3 4 5 6
F5A F3.15A
F3.15A F3.15A
J8
DA DB DA DB
L1 L2 L3
RS485 2 RS485 1
TAMPER OUTPUT
7 8 TA FA
J3
USB
RESET
J7
F3.15A
L4 L5 L6 L7 L8 L9 L10 T
VLINEE VLINEE
Peripherals
SUPPLYING
- 36 -
S1
J5
J6
S4
F2A
+SA +S C NC NO OUT IN
A B A" B"
VPOT ALARM SPK MIC
CONNECTION
TELEPHONE PSTN LINE
Towards
the others
. . . .
S2