Sunrise Medical Oxford Hoyer Stature Manual De Instrucciones Y Garantía Para El Usuario página 4

6
2.
Fit the legs to the chassis using two 6mm countersunk screws per leg as provided.
NOTE:
There is a left and a right leg and they are configured as shown below
3.
Using Allen Key provided, tighten the 6mm screws located on each side of the chassis.
The screws should be secured firmly.
4.
Insert the curved boom section into the boom carriage. Secure the assembly by
inserting the two 6mm countersunk screws into the blue capping plate provided in
the fastener kit, as shown below and tighten firmly.
294000.10017 Rev. B
E n g l i s h
WARNING
E n g l i s h
5.
Attach four point positioning cradle to the lift boom by inserting the split pin.
Ensure pin is secure.
1
6.
Stand the Stature upright and apply the brakes.
Be careful when lifting the Stature to the upright position, as it is heavy.
Fit hand control plug into the bottom of the control box located on the mast, ensure
correct alignment to the plug socket. Fit power pack to the lift and make sure the
latch holding the pack in place is fully engaged "Click" into place.
DISASSEMBLY
The lift should not be disassembled unless for service, repair or transport if necessary.
If disassembly is necessary, follow the assembly instructions in reverse sequence.
2
WARNING
294000.10017 Rev. B
7