End Of Job; Maintenance; Blade Removal And Fitting - inventiv INV T17051 TH Manual De Instrucciones

Cortadora de pasto con operador de pie

Ocultar thumbs Ver también para INV T17051 TH:

Tabla de contenido

Idiomas disponibles

8.4 END OF JOB

When work has been completed, release the brake lever (1) and disconnect the spark plug

cap (2).

WAIT UNTIL THE BLADE STOPS before making any adjustments.

Routine and accurate maintenance is essential in maintaining original machine safe-

ty and performance levels.

Store the lawnmower in a dry place.

1) Wear sturdy work gloves before cleaning, maintaining or adjusting the machine.

2) Accurately wash the machine with water after each mowing, remove grass debris and

mud accumulated under the chassis to prevent it from drying and causing problems the

next time the lawnmower is used.

3) P aint on internal chassis parts may come off over time due to the abrasive action of cut

grass; if this happens, promptly touch-up paint with rust-proof paint to prevent rusting that

could corrode the metal.

4) If accessing the lower part is necessary, only tilt the machine on the side indicated in the

engine manual, following the relevant instructions, making sure that the machine is per-

fectly stable before performing any interventions.

5) Do not drip petrol onto the plastic parts of the engine or the machine to prevent damaging

them and remove all traces of spilt petrol immediately. The warranty does not cover dam-

age to plastic parts caused by petrol.

Each adjustment made to the blade is best if done at a specialised Centre that has the most

appropriate tools.

Only blades with the following code must be used on these machines:

INV T17051 TH

81004459/0 - 81004462/0

9 EN

Tabla de Contenido

Tabla de contenido