S - Cup grille
T - Professional filter holder
U - Thermocream® Filter
V - Perforated silicone disc
W - Thermocream® Disc
control description
1 On/off light
2 Coffee temperature light
3 Steam temperature light
4 Dispenser filler light
5 On/Off button
6 Coffee brewing button
7 Steam button
8 Dispenser filler device button
Identification data
The following machine identification data are shown on the plate found underneath the machine's standing base:
• manufacturer and CE mark
• model (Mod.)
• serial number (SN)
• electrical supply voltage (V) and frequency (Hz)
• absorbed electric power (W)
• assistance toll-free number
Always give the model and serial number to the Authorised Service Centres when requesting assistance.
prelIMInAry phAses FOr use
starting the appliance
Check that the voltage of the domestic network is the same as that indicated on the technical information plate of the appli-
ance. Place the appliance on a flat surface.
Remove the water tank (H) from the opening on the machine (Fig. 3), fill with fresh natural water up to the Max mark (1.5 lt),
and refit it into its housing onto the body. In order to guarantee the correct operation of the appliance, push the tank down
as far as it will go. The tank may also be filled from the top, by pouring water through the opening and after lifting the filler
cap (I), Fig. 4. Plug the appliance into the mains.
starting the first time
Press the main switch (5) Fig. 2; the power light (1) will light up and light (2) will start blinking until the operating temperature
has been reached. Put a cup underneath the Maxi Cappuccino device and lower the water/steam lever (Fig. 5 - F), and, at
the same time, press the coffee brewing button (6) thus bleeding any air or water out of the circuit. Fill up at least a cupful of
water. Lift the water/steam lever (F) back up and stop the brewing cycle by pressing the coffee button (6).
it is recommended that this operation be carried out every time the machine is started after a few days it has not
been used.
For the daily refilling of the water tank, lift the filler flap (I) and pour in fresh natural water through the opening (Fig. 4).
Introduce the coffee into the coffee beans tank (D) Max 230 gr (Fig. 7).
Coffee may be ground coarse or fine, as per your personal preferences. To change the grinding level, press the stop button
(B) and turn the coffee grinder clock or anticlockwise, following the graded scale, Fig. 8.
this operation must only be performed with the grinder off.
Boiler heating and the dispensing function are cut out while the coffee grinder is operating
choice of the ground coffee supply device
The appliance is provided with two interchangeable devices:
1) "Continuous flow" device (M) Fig. 1 for the coffee instantaneous grinding. Put the filter holder into the specially provided
fork so as to press the button (M/a) located underneath the ground coffee opening, Fig. 9.
2) "Dispenser/Measuring Device" (N) Fig. 10. Keep the switch (8) Fig. 2 pressed until the ground coffee Dispenser is full:
operate the Measuring Device lever once or twice, according to how many cups of coffee you wish to prepare, and keep
the filter ring inserted into the fork. To release, pull the devices (M) or (N) in your direction.
If the coffee grinder jams, the dispenser filling indicator lamp (4) starts to blink. The reason might be that there are impurities
mixed with the coffee beans.
To unblock the coffee grinder, press the dispenser filling button (8) so that the blinking indicator lamp turns off. Press the
14