Make Electrical Connection - U.S.A. Only - Kenmore 191.57754412 Instrucciones De Instalación

MAKE ELECTRICAL CONNECTION – U.S.A. ONLY (EFFECTUER LE
RACCORDEMENT ÉLECTRIQUE – ÉTATS-UNIS SEULEMENT)
Electrical Connection Options
Before you start: disconnect power.
1.
Choose electrical connection type
Power supply cord 4-wire receptacle
(NEMA Type 14-30R):
Go to "Power Supply Cord Connection."
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "Power Supply Cord Connection."
4-wire direct connection:
Go to "Direct Wire Connection."
3-wire direct connection:
Go to "Direct Wire Connection."
NOTE: If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to "Optional
3-Wire Connection." This connection may be used with
either a power supply cord or a direct wire connection.
2.
Remove terminal block cover
Remove hold-down screws and terminal block cover.
10
POWER SUPPLY CORD CONNECTION
Power Supply Cord Strain Relief
1.
Attach power supply cord strain relief
A
B
C
D
Remove the screws from a 3/4" (19 mm) UL Listed strain relief.
Put the tabs of the two clamp sections (C) into the hole below
the terminal block opening (B) so that one tab is pointing
diagonally toward the dryer (A) and the other is pointing
diagonally away from the dryer (D), and hold in place.
Tighten strain relief screws just enough to hold the two
clamp sections (C) together.