Kenmore 191.57754412 Instrucciones De Instalación página 12

4.
Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tabs of terminal block cover
into slots of dryer rear panel. Secure cover with hold-down
screws. Now, go to "Venting Requirements."
3-Wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
3-wire receptacle
(NEMA type 10-30R)
Spade terminals
with upturned ends
1.
Remove center screw
Remove center terminal block screw (B).
12
3-prong plug
Ring terminals
B
2.
Connect neutral wire
Connect neutral wire (white or center) (C) of power supply cord
to center terminal block screw (B). Tighten screw.
3.
Connect remaining wires
Connect remaining wires to outer terminal block screws. Tighten
screws. Finally, reinsert tabs of terminal block cover into slots of
dryer rear panel. Secure cover with hold-down screws. Now, go
to "Venting Requirements."
C
B