Page 16
Solid Green: Remote Control
2.
On some models, an LED light illuminates
the interior area of the body and canister.
✳ not available on all models
NOTE: LED lights may be difficult to see in sunlight.
In-App Error Messages and
Troubleshooting
If an error occurs, the status bar will show a
warning symbol and: "Cleaning Interrupted".
1. Click on the warning symbol to view
troubleshooting advice
on how to fix the issue.
2. Choose Clear Error if you believe you have
fixed the problem and want to re-try. Choose
OK if you want to suspend the cleaner in
error mode and work on the troubleshooting
fix at a later time.
System Settings
Access System Settings by pressing the gear
icon in the upper right hand corner of the app
screen.
7
Maintenance
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.
Cord Tangling
Tangling can occur more frequently when the
cleaner is not attended to after each cleaning cycle.
The tangle-reducing swivel, in addition to proper
installation, general maintenance and the following
troubleshooting steps can help to avoid cable
challenges.
IMPORTANT
Cleaner power cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the middle
of the pool length (Figure 15). Only place enough
cable in the water to reach the farthest point in the
pool.
cleaner
cleaner
Max
Floating Cable
Length
Figure 15. Optimal Entry Point in Pool
If tangling occurs, follow these steps:
1.
Remove the cleaner from the pool using
the Lift System. When the cleaner is within
arm's reach, use the handle to remove from
the water. Never lift the cleaner out of the
pool by the floating cable or swivel.
2.
Hold the cleaner vertically to drain
(Figure 16).
Not
Recommended
caddy /
control unit
Recommended
entry point
WARNING: Do not use
an extension cord