Attach The Control Box To The Caddy; Connect To A Power Source - Polaris ROBOTIC Alpha iQ+ Manual Del Propietário

Page 8

Attach the Control Box to the Caddy

1. Align the bottom of the control box with the
notch at bottom of the control box hook on
the caddy (Figure 8).
Figure 8. Align Control Box with Caddy Hook
2. Press control box onto the caddy hook until
it snaps and locks into position (Figure 9).
Figure 9. Attach the Control Box onto Caddy

Connect to a Power Source

WARNING
Failure to comply with the following warnings
can result in permanent injury, electrocution or
drowning.
PREVENT ELECTRICAL SHOCK
• U.S.: Per NEC requirements, keep the control
®
box at least five (5) ft. (1.5 m) from the edge of the
pool. CANADA: Per CEC requirements, keep the
control box at least three (3) m (10 ft.) from the
edge of the pool.
• Only connect the control box to a receptacle
protected by a ground fault circuit interrupter
(GFCI). Contact a certified electrician if you cannot
verify that the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the
control box.
• Do not allow anyone to swim while the cleaner is
in the pool.
• The control box is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control box or leave exposed to inclement
weather.
1. Unscrew the protective cap for the floating
cable from the side of the control box by
turning counter-clockwise (Figure 10).
Figure 10. Remove Protective Cap