Store The Cleaner When Not In Use - Polaris ROBOTIC Alpha iQ+ Manual Del Propietário

Page 18
4. Remove the filter canister assembly from
the body (3), as shown in Figure 20.
3
Figure 20. Remove Filter Canister Assembly
5. Push the quick release button on the
canister assembly (4) and pull open
Figure 21.
Figure 21. Open Filter Canister Assembly
6. Separate the filter canister from the filter
support (6), as shown in Figure 22.
Figure 22. Remove Filter Canister
7. Empty all debris from the filter canister,
then rinse the canister, the filter support
and the cleaner using a hose, as shown in
Figure 23.
Figure 23. Wash Filter Canister
NOTE: Periodically, remove the filter canister and clean
thoroughly with soapy water
and a soft bristle brush.

Store the Cleaner When Not in Use

The cleaner should be cleaned regularly using
slightly soapy clean water. Do not use solvents
such as trichlorethylene or its equivalent. Rinse
the cleaner generously using clean water. Do not
let your cleaner dry in direct sunlight near the pool.
The cleaner should be stored on its caddy so that it
dries quickly.
1. Disconnect cleaner from the power source.
2. Starting at the cleaner head, remove all
coils and tangles from the cable (Figure
24). Lay the cable in the sun to loosen any
tangling memory.
3. Place the rear wheels on the caddy and
position the cleaner vertically on the caddy
base.
4. Disconnect the cable from the control box.
Replace the protective cap on the control
box.