Troubleshooting - Weston PRO-2500 Manual De Instrucciones

TROUBLESHOOTING

Q: Nothing happens when the Power Button is pressed!
1. Make sure that the Power Cord is not damaged in any way.
2. Be sure that the female end of the Power Cord is plugged completely into
the Power Supply Port of the Vacuum Sealer, and that the male end of the
Power Cord is firmly plugged into the wall outlet
Q: My Vacuum Sealer shut off and will not start again.
1. The Thermal Overload Protector may have been activated. In this case, allow
the Vacuum Sealer to cool by opening the Vacuum Lid for approximately 20
minutes. Be sure to leave the Vacuum Lid open between bag sealing.
2. Be sure that the female end of the Power Cord is plugged completely into the
Power Supply Port of the Vacuum Sealer, and that the male end of the Power
Cord is firmly plugged into the wall outlet.
Q: The Sealing Bar melts through the bag.
1. The Chamber Vacuum Sealer is ONLY intended to be used with CHAMBER
VACUUM BAGS. DO NOT USE HOUSEHOLD BAGS OR EMBOSSED BAGS
INTENDED FOR USE WITH OUT OF CHAMBER SEALERS!
2. Check the condition of the Seal Bar Tape strips.
3. Open the Vacuum Lid and allow the sealing bar to cool for 5-10 minutes.
Always leave the Vacuum Lid open between bags, and allow at least 20
seconds between cycles.
4. The Sealing Bar time may need to be lowered. Adjust the Seal Time Down
(-) in one second increments and try the test process again. Refer to the "Initial
Testing of the Bag Seal" instructions in this booklet for more information.
Q: The bag seal pulls apart.
1. If the seal has not fully welded the bag closed, trim off the bad seal with
scissors and adjust the Seal Time Up (+) in one second increments and try the
test process again.
2. The Chamber Vacuum Sealer is ONLY intended to be used with CHAMBER
VACUUM BAGS. DO NOT USE HOUSEHOLD BAGS OR EMBOSSED BAGS
INTENDED FOR USE WITH OUT OF CHAMBER SEALERS!
3. The seal of the bag may be incomplete. If the seal has a crease in it, or if a
liquid or powder has been trapped between the layers of the bag, the layers may
not have been welded together properly. Cut the seal off and wipe the inside of
the bag clean. Then, try to vacuum seal the package again.
NOTE: The Chamber Vacuum Sealer is ONLY intended to be used with CHAMBER
VACUUM BAGS. DO NOT USE HOUSEHOLD BAGS OR EMBOSSED BAGS
INTENDED FOR USE WITH OUT OF CHAMBER SEALERS! Any other uses of the
Vacuum Sealer, other than the uses described in this booklet, could potentially damage
the appliance and void the warranty!
13