HAMPTON BAY Argenta 872 092 Manual Del Propieratio página 10

BLADE BALANCING
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched.
The following procedure should correct most
fan wobble. Check after each step.
1. Check that all blade and blade brackets are
secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on
8.
the ceiling. Measure this distance as shown
in Figure 14. Rotate the fan until the next
blade is positioned for measurement. Re-
peat for each blade. Measurement devia-
tions should be within 1/8". Run the fan for
10 minutes.
3. Use the enclosed Bladed Balancing Kit if
the blade wobble is still noticeable.
Figure 13
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
Installing the Light Kit
and Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Loosen, but do not remove, two of the three
mounting screws and lockwashers on the
black bracket below the fan motor assem-
bly; remove the other mounting screw and
lockwasher (Figure 15).
Figure 14
Figure 15