HAMPTON BAY Argenta 872 092 Manual Del Propieratio página 11

2. Route the blue wire and white wire from the
center hole of the lower housing; route the
black and white wires through the center
hole of the lower housing.
3. Position the lower housing onto the black
bracket of the fan motor assembly, align-
ing each of the three holes. Rotate the
lower housing clockwise to engage the two
mounting screws and lockwashers with the
two key hole slots, tighten the screws and
lockwashers. Re-install the one mounting
screw and lockwasher that were removed in
step 1 and tighten firmly. Connect the black
and white wires from the fan motor assem-
bly with the black and white wires from the
lower housing by engaging the 2-positioned
connectors (Figure 15).
4. Loosen, but do not remove, two of three
mounting screws and lockwashers on the
lower housing; remove the other one screw
and lockwasher (Figure 16).
5. Connect the blue and white wires from
the fan motor assembly with the black and
white wires from the light kit fitter by en-
gaging the 1-positioned connectors (blue to
black; white to white). Carefully tuck all the
wires and connectors into the recess of the
lower housing (Figure 16).
6. With power off, insert the CFL spiral lamp
(Max. 14W, provided) into the light socket
(Figure 17).
7. Place the glass into the lower housing,
aligning the three flat areas on the top flange
of the glass with the three raised dimples in
the lower housing. Turn the glass clockwise
until it stops (Figure 17).
NOTE: PERIODICALLY
GLASS SHADE IS SEATED FULLY CLOCK-
WISE IN THE LOWER HOUSING.
Figure 16
CHECK THE
Figure 17
9.