Kit Preparation - Metra 99-7620B Instrucciones De Instalación

Attention! Hand tools are highly recommended
as the factory dash may break with the use
of power tools.
1. Remove the climate module from the
display screen/climate module brackets.
(Figure A, shaded portion)
2. Secure the climate module to the model
specific set of screen brackets with the
(4) #8 x 3/8" Phillips screws supplied.
(Figure B, shaded portion)
3. Remove the display screen from the
display screen/climate module brackets.
(Figure A)
4. Secure the display screen to the model
specific set of screen brackets using the
factory hardware. (Figure B)
5. Reconnect and secure the completed
assembly to the dash using the factory
hardware.
Note: It may be necessary to file the
inside edges of the top (2) screen mounts
to accommodate the display screen. The
factory brackets will not be reused.
4

KIT PREPARATION

(Figure A)
Armada brackets
shown for illustration
purposes
(Figure B)
6. Remove the (4) Torx T-20 screws
securing the radio chassis to the radio/
climate control panel, and then remove.
(Figure C)
7. Remove the Torx screws securing the
radio and climate controls buttons to the
radio/climate control panel, and then
remove. (Figure C)
8. Secure the HVAC control panel, and
the (2) outboard control panels, to the
factory radio/climate control panel using
the factory hardware. Leave the top (2)
mounting screws out for kit assembly.
(Figure D)
Continue to Kit Assembly
(Figure C)
(Figure D)
|
1.800.221.0932 MetraOnline.com