Final Assembly; Screen Operation - Metra 99-7620B Instrucciones De Instalación

FINAL ASSEMBLY

1. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Metra recommends using the proper mating adapter from Metra.
2. Before using the kit it must be initialized.
Attention! If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an ASWC-1 connect it after you initialize and test the interface/
radio, with the key in the off position.
a. Turn the key (or push-to-start button) to the ignition position and wait until the factory
display screen comes on. The screen should come on within 30 seconds.
Note: If the screen does not come on, turn the key to the off position, disconnect the
interface, check all connections, reconnect the interface, and then try again. Ensure that
the display harness is connected.
b. Start the vehicle and test all functions of the installation for proper operation, before
reassembling the dash.
Note: The rear seat climate controls (if applicable) will no longer function with this kit.
3. Secure the completed assembly into the dash, and then reassemble the dash in reverse
order of disassembly.

SCREEN OPERATION

Settings:
All button functions are retained and controlled in the same manner that the factory
buttons were controlled.
(Example: Tire Pressure, Fuel Economy, Brightness, Clock Setting, etc).
Note: The 2 blank buttons on the HVAC control panel will not be used in this application.
Continued on the next page
11
REV. 5/24/2019 INST99-7620B