Without Bose Amplifier - Metra 99-7620B Instrucciones De Instalación

For models without a BOSE amplifier:
From the 20-pin harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Disregard the 12-pin harness with RCA jacks, it will not be used in this application.
• Connect the Blue/Pink wire to the speed sense wire (if applicable).
• If retaining the factory AUX-IN jack, connect the Red and White RCA jacks labeled "AUX
Input" to the AUX input.
CONNECTIONS
7620-MAIN harness (for models without factory navigation)
• Disregard the Red and White RCA jacks labeled "From DVD", they will not be used in this
application.
• Disregard the Yellow RCA jack labeled "From DVD", it will not be used in this application.
Note: This 16-pin harness must be connected for the factory backup camera to function.
There are (2) 16-pin harnesses in the vehicle. Use the 16-pin harness that was connected into
the factory radio chassis.
• If an aftermarket backup camera or external video source is desired to be displayed to the
factory display screen, connect the Yellow RCA jack labeled "Backcam" to the desired source.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Continue to Installation
7
REV. 5/24/2019 INST99-7620B