Kenmore 137.23671310 Manual De Uso Y Cuidado página 28

Troubleshootincj (continued)
ELECTRONIC IGNITION:
No spark, no ign tion noise.
, No spark, some ignition noise.
* Sparks, but not at electrode or at fuji
strength.
Burner(s) will not light
using igniter.
(See Electronic
Ignition
Troubleshooting also)
Burner(s) will not
match light.
See "GAS ISSUES:' on previous
page.
" Match will not reach.
" Improper method of match-lighting.
" See Section I of Electronic Ignition System.
_ See Section II of Electronic Ignition System.
See Section JJJ of Electronic Ignition System.
Use long-stem match (fireplace match).
• See "Match-Lighting" sect on of Use and Care.
" Out of gas. • Check for gas in LPcyl rider.
Sudden drop in gas
flow or low flame.
Flamesblow out.
Flare-up.
Persistent grease fire.
Flashback...
(fire in burner tube(s)).
° Excessflow valve tripped.
" Vapor lock at coupling nut/LP
cylinder connection.
° High or gusting winds.
" Low on LPgas.
'_ Excess flow valve tripped.
° Grease buildup.
• Excessive fat in meat.
" Excessive cooking temperature.
" Grease trapped by food buildup
around burner system.
" Burner and/or burner tubes are
blocked.
• Some dealers have older fill nozzles
with worn threads.
° Grease buildup or food particles in
end (s) of carryover tube(s).
• Turn off knobs, wait 30 seconds and light grill Jfflames are
still low, turn off knobs and LPcylinder valve. Disconnect
regulator. Reconnect regulator and leak-test. Turn on LP
cylinder valve, wait 30 seconds and then light grill
oTurn off knobs and LPcylinder valve. Disconnect coupling nut
from cylinder. Reconnect and retry.
• Turn front of grill to face wnd or increase flame he ght.
° Refill LPcylinder.
, Refer to "Sudden drop in gas flow" above.
• Clean burners and inside of grill/firebox.
" Trim fat from meat before grilling.
Adjust (lower) temperature accordingly.
• Turn knobs to OFF.Turn gas off at LPcylinder. Leave lid in
position and let fire burn out. After grill cools, remove and
clean all parts.
" Turn knobs to OFF.Clean burner and/or burner tubes. See
burner cleaning section of Useand Care.
• The worn nozzles don't have enough "bite" to engage the
valve. Try a second LPdealer.
Clean carry-over tube(s) with wire brush.
Unable to fill LP
cylinder.
One burner does
not light from
other burner(s).
REV 2
28 _ 23671_46477279