Step 12
1
D24
I
Groove
Insert the DRAWER SIDES (D24 and D25) at an angle
å
into the slot at each end of the DRAWER FRONT (I).
3
Fasten the DRAWER BACK (D109) to the DRAWER SIDES (D24 and D25). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of the DRAWER BACK (D109).
å
Page 16
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D25
D109
D24
D716
VIEW THE T-LOCK BOX VIDEO
2
D24
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D716) into the grooves in the
å
DRAWER SIDES (D24 and D25) and DRAWER FRONT (I).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
D25
420567
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
e d
s u r
f a c
e
D716
D25
I
30S
www.sauder.com/service