Display Assembly - Health O Meter PROPLUS 2000KL Instrucciones De Uso

ASSEMBLY INSTRUCTIONS (CONTINUED)

Display Assembly:

10. Position the Display Assembly close to the Display Support. Connect the load cell cable
connector to the load cell port on the rear of the Display Assembly and insert and secure the
cable into the center channel in the display. See Figure 4, for an illustration. Note: Do not
attach the power cord at this point—wait until step 13.
11. Slide the display assembly onto the display support by inserting the two metal supports into
the two slots in the rear display assembly. Note: The load cell cable should now be
secured in the channel between the display assembly and the display support.
12. Insert the 4 screws into the display support and tighten.
13. Connect power cord to the power port in the display assembly and insert and secure the
cable into the exposed portion of the second channel from the left in the back of the display.
Do not plug the scale into a power source until the scale is fully assembled.
14. Insert the power cord into the retaining slot on the rear cover. Align the rear cover tabs with
the slots on the rear of the display assembly. Apply pressure to snap the rear cover into
place and secure with 2 screws.
- 10 -