Cequent Performance Products T-One 118272 Instrucciones De Instalación

Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-One T-Connector
®
T-One Connecteur en T
®
T-One Conector en T
®
Ford Explorer
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l'installation. Durant
l'installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
118272-037 Rev. A 2/16/2015
d
ENGLISH
TOOLS REQUIRED:
Wire Cutters, Philips Head Screwdriver,
Test-probe
1. Locate the vehicle's Tow-Plug harness
underneath the vehicle, on the passenger's
side. The connection point will be behind the
rear tire and have connectors matching the
T-One ® T-Connector harness. Separate this
connector, being careful not to break the
locking tabs. All connector surfaces should
be clean and free of dirt d .
2. Insert the T-One
vehicle's Tow-Plug harness and lock into place.
3. Determine 7-Way mounting location. Route the
harness containing the 7 wires along the inside
of the bumper toward the center of the vehicle
and to 7-Way mounting location.
NOTE
See 7-Way diagram for wire locations e .
WARNING
Route the wire being careful to avoid any hot
pipes, heat shields, the fuel tank or any other
points that may pinch or break the wire.
WARNING
All connections must be complete for the
T-One ® T-Connector to function properly.
Test and verify installation with a test light
or trailer once installed. For initial test, reset
vehicle electrical system by temporarily
removing the key from the ignition.
T-Connector harness into the
®
PAGE 1 OF 3
7-WAY CONNECTOR
BLACK
BROWN
BLUE
YELLOW
CAR END
As viewed from core back side where
wires are attached with screws.
e
4. Secure the remainder of the harness with the
cable ties provided, to prevent damage or rattling
and being careful to avoid any areas that would
pinch, cut or melt the wire.
WARNING
Overloading circuit can cause fires. DO NOT
exceed lower of vehicle manufacturer rating or:
• Max. stop/turn light: (10 amps)
• Max. tail lights: (10 amps)
• Max. backup: (10 amps)
• Max. power circuit: (30 amps)
• Max. trailer brakes: 3 Axles/6 brakes (20 amps)
Read vehicle's owners manual & instruction sheet
for additional information.
GREEN
RED
WHITE