Feed In Wire; Trigger 2-Cycle Function - Abicor Binzel RBC 61GD Instructivo De Servicio

5 Operating elements

4.5 Feed in wire

5 Operating elements

5.1 Trigger 2-cycle function

6 Operation
7 Removal from service
EN - 8
NOTE
• Each time the wire is changed, make sure that the cutting point is free of
burrs.
1 Insert the wire in the wire feed unit as specified by the manufacturer.
2 Press the "Wire Jog" push-button at the wire feed unit until the wire comes
out of the contact tip.
NOTE
• As the MAG welding torches are integrated into a welding system, the
operating instructions of the welding components, such as welding torch
and power supply, must be observed during operation.
Using a standard welding torch, the two-cycle mode of the trigger can be
activated.
1 1 Press the trigger on the handle and keep it pressed = welding is started.
2 2 Release the trigger = welding is stopped.
1 Open the shielding gas cylinder.
2 Switch on the power supply.
3 Setting the welding parameters.
1 Wait until the shielding gas flow has subsided.
2 Switch off power supply.
3 Close the valve of the shielding gas cylinder.
MAG