Installation Checklist; Operation; Led Status Indicators - Slingshot Field Hub Manual De Instalación

Installation Checklist

Once the installation of the Field Hub™ is complete, verify that the Field Hub
is working properly by checking the following items:
Note: The Field Hub may take up to 3 minutes to start up. Allow the Field
Hub sufficient time to power up before checking these items.
• Signal LED is on (solid light) or flashing.
• WAN LED is on (solid light) or flashing.
• RS-232 LED should be flashing approximately once a second if a valid
Slingshot™ RTK subscription has been activated.
• GPS LED is on (solid light).
• Field Hub™ powers on/off with the ignition.
Note: The Field Hub goes through a power down sequence when the ignition
key is switched off. It is normal for the Power LED to remain on for
approximately 60 seconds after the ignition switch is turned off.

Operation

LED Status Indicators

• Power - The power indicator is lit when the Field Hub is powered on.
Note: The Field Hub goes through a power down sequence when the ignition
key is switched off. It is normal for the Power LED to remain on for
approximately 10 seconds after the ignition switch is turned off.
• Signal - The Signal LED displays the current cellular signal strength. This
indicator will be off for weak or no signal (less than -100 dBm), flashes
faster as signal strength increases, and is on (solid) for excellent signal.
• WAN - The WAN LED displays the status of wireless communications.
This LED will be on (solid) when a link is established but no current data
activity. A flashing light indicates data is being transmitted/received over
the wireless network.
• 232 - This indicator displays activity with a serial device. A flashing light
indicates a link with a serial device is established. Data may be
transmitted/received between the Field Hub and the serial device.
• GPS - The GPS LED indicates the status of the GPS coming into the Field
Hub via the 'GPS' connection on the back of the Field Hub (not your GPS
receiver). This indicator is on (solid) when a position fix is available, off
when no fix is available.
• Reset - Do not press the Reset button unless instructed by Raven support
personnel.
English
4