Sensor Programing - Okoru Global SmartSun Manual De Instrucciones

5.
SENSOR PROGRAMMING
5.1 CHECKING THE SENSOR MODE AND FUNCTION
Before beginning sensor programming, make sure that the sensor-receiver mode and function match
in order to add the transmitter correctly.
To carry out this check, the wind sensor must be connected to the electric current and we will obtain
one of the following cases:
• 1. The LED indicator blinks 1 time and turns off. Mode 1, the sensor outputs signal to fit all
common Dooya receivers. Conventional mode.
• 2. The LED indicator blinks 2 times and turns off. Mode 2, the sensor outputs signal to specially
match a special non-Dooya receiver.
• 3. The LED indicator blinks 3 times and turns off. Mode 3, the sensor is in hold function, not used.
• 4. The LED indicator blinks 4 times and turns off. Mode 4, not used for awnings.
5.2 CHANGING THE SENSOR MODE AND FUNCTION
• Disconnect the sensor from the electrical current
• The green indicator will blink as many times as the mode you are in. The light will turn off and
enter standby mode.
• Press the UP button and P2 button on the sensor at the same time for 5 seconds, the indicator
will flash. Sensor enters mode setting state.
• Press the P2 of the sensor as many times as changes of mode are desired until reaching the
desired mode.
• The sensor will output the signals indicated for the selected mode.
5.3 SYNCHRONIZATION OF SENSOR-MOTOR
To synchronize the sensor with the awning motor, the following steps must be followed. First of all, the
controller must be paired with the motor:
• Disconnect the motor and wait a few seconds to plug it back in. The motor will beep.
• (Within 5 seconds) Press the "P2" button on the remote control, located on the back next to the
battery, twice. A beep is heard for each press.
• Then press the UP button. 3 motor beeps will be heard.
• Check that the awning closes when we press the UP button.
• Plug the sensor into electrical power.
• Press the "P2" button on the remote control twice, located on the back next to the battery. A
beep is heard for each press.
• (Within 6 seconds) Press the "P2" button on the feel sensor once. 3 motor beeps will be heard.
• Configuration OK.
16