General Notices - Diamond E77/FB8 Manual Del Usuario

- The installation, initial operation, and maintenance of the oven must only be carried out by specialized and authorized
personnel, by licensed installers, or by personnel authorized by the manufacturer.
- Read the instructions in this manual carefully, as they supply important information on the safety of
installation, use, and maintenance.
- Keep this manual for the future use of all interested personnel.
- After removing the packaging, check that the equipment is intact.
- If you have any doubt about the condition of the equipment, or if there is obvious damage or anomalies, do not use
the oven and consult the qualified personnel immediately.
- Do not leave the packaging materials (plastic bags, polystyrene pads, nails, etc.) in the reach of children, as they
are potential sources of danger.
- Before hooking up the oven, make sure that the information on the serial plate corresponds to that of the electrical,
and water lines to be used.
- The serial plate is located in the lower part of the front side of the oven.
- The oven must only be used by specially trained personnel.
- This equipment must only be used for the purpose for which it was designed, i.e. for cooking or re-heating food.
- Any other use is inappropriate and is therefore to be considered dangerous.
- Do not obstruct the air vents or heat dissipation openings.
- Always switch off the oven after use.
ELECTRICAL INFORMATION
The electrical safety of this equipment is only ensured when the oven has been correctly connected to a good earth
as prescribed by the regulations on electrical safety in force.
It is absolutely essential to verify this basic requirement, and if you have any doubt, ask professionally qualified
personnel to make a careful check of the system.
The manufacturer cannot be considered responsible for any damage caused by the lack of earthing of the
system.
The oven must also be included in an equipotential system whose efficiency must be verified according to the
regulations in force.
Connection is made by means of a screw marked with the "equipotential" sign located near the terminal strip.
On installation, a general switch must be provided for the cable hookup, with a contact separation of at least 3 mm.
The flexible cable for hooking up to the electrical line must have characteristcs that are not inferior to the H07RN-F
type with rubber insulation.
In the event of the user or the installation technician failing to observe the instructions given in this manual, the Firm
disclaims all responsibility thereof and cannot be held liable for any accidents or trouble caused by such non-observance.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY INACCURACIES IN THIS BOOKLET THAT MAY BE
DUE TO TYPING OR PRINTING MISTAKES. THE MANUFACTURER, MOREOVER, RESERVES THE RIGHT TO MAKE THE
MODIFICATIONS TO THE PRODUCT IT CONSIDERS USEFUL OR NECESSARY, WITHOUT AFFECTING ITS BASIC FEATURES.

GENERAL NOTICES

- 12 -