Dnis; Account Code; Enable Supervision; Supervision Time - DSC GS3100 Manual Del Usario

Telephone numbers to decode
Up to 4 telephone numbers called by the control unit may be entered in these boxes (the number should be composed of at
least 2 digits). When the Communicator recognises a call from one of these numbers, communication via GPRS begins
automatically. Every time a number called does not correspond to one of the numbers entered, the call is transmitted over
a vocal channel. If no telephone numbers are entered, the Communicator will use the GSM or PSTN line.
, , , , , ATTENTION: The dialled number appearing in the "Digits to remove" area shows that the call is being sent
on the vocal channel or GPRS, e.g.:
1) if the input telephone number called from the key panel is 0123, the numbers input in the digits to be
removed area is 2 and the composed number is 0123, the call is being sent on the vocal channel;
2) if the input telephone number called from the key panel is 0123, the number input in the digits to be
removed area is 2 while the composed number is 000123, the call is being sent on the GPRS channel.

DNIS

If required, enter the Dialled Number Identification Service number.

Account code

An account code is required for communication with WinBCS application, or Sur-Gard SYSTEM III or SYSTEM II receivers.
Enter the Account Code in this field.

Enable Supervision

To enable supervision, select this option. The supervision option is ONLY available to the primary receiver.

Supervision time

Set the Supervision time for the monitored zones. It is possible to set a Supervision time between a minimum of 1 second
and a maximum of 65535 seconds, with steps of 1 second.

Status

This page will allow you to monitor and control in real-time all the Communicator functions.
, , , , , ATTENTION: This page is updated every 5 seconds.

Status section

This section lists the most important data relating to the GSM module. The virtual display shows, in addition to the name of
the GSM network manager, the GSM signal strength (this is displayed through a special indicator).
The Device status indicator may be ON or OFF .The Device status indicator light is normally GREEN: when it is RED, this
indicates that there is no communication between the software and the Device; if it is AMBER it means that details of the
Device status are being acquired.
GS3100
G G G
G G
15