ANT-EU Remote antenna
4b. For details of how to fit the ANT-EU remote antenna (Fig.3b), please refer to the instructions supplied.
5. Connect the wire [3] to the GSM antenna connector [4].
6. Complete the connections on the terminal blocks [10].
7. Following the arrow, insert the SIM-CARD [8] face down in the SIM holder (see Figure 1).
! ! ! ! !
The SIM-CARD PIN must be disabled before the card is inserted into the transmitter.
8. Make sure that all the green LEDs flash when the product is switched on; this means the device is in its initialisation phase.
Fig. 2 - Fitting the Communicator board inside the control panel.
6
GSM/GPRS Alarm Communicator