Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING
THE ROUTER TABLE
TOOLS
REQUIRED
(not included)
•
Phillips screwdriver
•
Small sized adjustable wrench
•
Tape with adhesive backing
ROUTER
TABLE LEGS (FIGURES
1A-lC)
1.
Insert eight 1/4-20x1-1/2" long carriage
bolts (43) through the router table top as
shown in Figure 1A.
2.
Place a strip of tape with adhesive backing
over the bolts to temporarily hold them
in place.
3.
Turn the router table top upside down.
4.
Place a leg reinforcement over each set of
carriage bolts as shown in Fig. lB.
5.
Assemble one of the legs to the router table
as shown in the figure.
6.
Assemble a 9/32" ID x 5/80D"
x 1/16" thick
washer (40) and a 1/4-20 "KEPS" nut (32)
onto each of the bolts.
7.
Securely tighten the fasteners.
8.
Repeat this procedure for the other side of
the router table as shown in Fig. 1C.
9.
Securely tighten the fasteners.
10. Turn the router table right side up.
11. Remove the tape holding the bolts in place.
Figure
1A
_"
lc/4_2tgl "10/2;
Figure 1B
9/32 x 5/8 x 1/16" washer
1/4-20 KEPS nut
Leg
_/
reinfor_
Figure lC
13
Publicidad
