Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING
UP THE FENCE
TO ADJUSTTHE
FENCE
OPENING
FOR
ROUTER
BIT CLEARANCE
(FIGURE 29)
1,
Loosen the two fence clamping knobs on both
the right and left side of the upper fence.
2,
Move the lower fences to the desired position
relative to the bit,
3.
Securely retighten the fence clamping knobs.
TO ADJUSTTHE
DEPTH
OF CUT
(FIGURE
29)
1.
Loosen the two clamping knobs.
2.
Slide the fence in or out relative to the cutter.
NOTE: Holding the fence at both ends while
sliding it will make it easier to move.
3.
Securely retighten the clamping knobs.
TO ADJUSTTHE
FENCE
FOR JOINTING
(FIGURE 29)
1.
Loosen the two fence clamping knobs holding the
left lower fence to the upper fence.
2.
Slide the fence to the left until it is fully
disengaged from the upper fence.
3.
Rotate the lower fence 180 ° and reassemble
to the upper fence, making sure the weld nuts
engage the slot in the lower fence and the tab
on the upper fence engages the slot on the
lower fence.
4.
While pressing the lower fence against the upper
fence, retighten the two fence clamping knobs.
TO ADJUST
THE ROUTER
BIT HEIGHT
To adjust the depth of cut into the workpiece, consult
your router owner's manual.
I -_WARNINGI
Some routers, when positioned
upside down (such as on a router table), will drop
or fall out of the router base when the base clamp
is loosened to adjust the height or depth of cut.
Be sure the router is supported from below when
adjusting or whenever the base clamp is loosened.
Figure 29
Clamping knob
Clamping knob
used to adjust
used to adjust
depth of cut
depth of cut
\
J
Left lower fence
Fence clamping knobs
used to adjust fence
opening for router
bit clearance and
Fence clamping knobs used
to adjust fence opening for
router bit clearance
for jointing
INSTALLING
THE ROUTER BIT
TOOLS
REQUIRED:
• Router collet wrench (included with router)
Because of the large variation of reuters and router
bits, certain router bits may not always operate in the
desired manner with this router table.
Install and position the router bit in the router collet
as described in the router owner's manual.
IA
I
i ,,.WARNINGI
BEFORE each and every use of
the router table, make sure that the floor stand, on
those models having one, is STABLE on the floor
and DOES NOT rock back and forth. If it does, level
the floor stand as described in a prior section.
On those models mounted on a workbench,
BEFORE each and every use make sure that the
router table is stable and securely mounted to the
workbench and is not free to move about or tip over.
If it does, remount the router table to the workbench
so that it is securely mounted.
34
Publicidad
