Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING
THE FEATHER BOARDS
(applies to model 171.264640
only)
IA
I
i nWARNINGI
THE FEATHER BOARDS
ARE NOT TO BE USED WITH ANY TABLE SAW,
POWER TOOL, OR ANY OTHER ACCESSORY,
OR ON ANY ROUTER TABLES OTHER THAN
THE 171.26463 AND 171.26464.
INSTALLATION
ON THE TABLE TOP
(FIGURE
30)
1.
Insert a 1/4-20 x 1-1/2" carriage bolt (43)
through the elongated slot on each end of the
feather board. Be sure that the diagonal of the
"feather" points in the feed direction.
2.
Attach a 9/32" ID x 5/8" OD x 1/16" washer (40)
and large clamping knob (4) to each bolt. DO
NOT TIGHTEN the clamping knobs at this time.
3.
insert the bolt heads through the round holes in
the key holes in the table top.
4,
Slide the feather board to the left until the
carriage bolt necks are fully seated in the
key slots.
Tighten the clamping knobs SECURELY.
INSTALLATION
ON THE FENCE
(FIGURE
31)
1.
Insert a 1/4-20 x 1-1/2" carriage bolt (43)
through the elongated slot on each end of the
feather board. Be sure that the diagonal of the
"feather" points in the feed direction.
2.
Attach a 9/32" ID x 5/8" OD x 1/16" washer (40)
and large clamping knob to each bolt. DO NOT
TIGHTEN the clamping knobs at this time.
3.
From the ends of the upper fence, slide the bolt
heads into the T-slot on the front of the upper
fence rail until the feather board is in the desired
position. Make sure that the feather board does
NOT restrict movement of the guard. Tighten the
clamping knobs securely.
Figure 30
1/4-20 x 1-1/2"
_
carriage bolt
:
.
Figure 31
I/4-20 x 1-1/2"
carr,age0o,t
35
Publicidad
