Publicidad
Idiomas disponibles
Idiomas disponibles
A
ON (RESET)
With red slide panel in this position,
switch can be toggled to ON (RESET).
Toggle switch with cover raised and switch
in the ON (RESET) position. Safety key
has been inserted in the side of the case.
Note the position of the red slide panel; this
is the normal position when the switch is in
the ON (RESET) position.
B
ON (RESET)
With red slide panel in this position,
switch can be toggled to OFE
Toggle switch with cover raised and
switch in the OFF position. Safety key
has been inserted in the side of the
case. Note the position of the red slide
panel; this is the normal position when
the switch is in the OFF position.
C
With red slide panel in this position,
switch can NOT be toggled to
ON (RESET).
Toggle switch with cover raised and switch
in the OFF position. Safety key has been
removed from the side of the case. Note
the position of the red slide panel; this is
the normal position when the switch is in
the OFF position and the key is removed.
To operate the switch, proceed as follows:
MAKE SURE THAT THE EXTENSION CORD IS
NOT PLUGGED INTO AN ELECTRICAL OUTLET
BEFORE PROCEEDING
ANY FURTHER.
1.
Insert the safety key into the side of the switch
case. See Figure 23 on page 28.
2.
To turn the router ON, lift the switch cover and
toggle switch to ON (RESET) position. See A
above.
Gently lower the switch cover. Letting the
switch cover drop closed may cause the switch
to turn OFF by activating the EMERGENCY OFF
feature.
3.
To turn the router OFF, liftthe switch cover
and toggle the switch to the OFF position.
See B above.
In an emergency, the switch can also be turned
OFF by slapping or striking the switch cover.
I -_WARNINGI
NEVER LEAVE THE
ROUTER UNATTENDED WHILE IT IS
RUNNING OR BEFORE IT COMES TO
A COMPLETE STOP.
4
To lock switch to OFF position, toggle the switch
to OFF and remove key completely from the side
of the switch case. See C above.
5
Make sure the red slide panel covers the top
half of the toggle switch once the safety key
is removed, as shown in C above.
If the red slide panel does not cover the top
half of the toggle switch once the safety key
is removed, press down on the switch toggle
under the word OFF.
If the slide panel still does not cover the top half of
the switch:
• Unplug ALL electrical connections.
• Remove the switch from the router table and
obtain a replacement switch from your local
Sears outlet.
The router table can still be used by plugging the
router into a suitable outlet and using the ON/OFF
switch on the router.
With the safety key removed and the red slide panel
covering the top half of the switch toggle, the switch
CANNOT be toggled to the ON position.
29
Publicidad
