Using A Mains Adapter; Setting Mode - ProMed PBM-3.5 Instrucciones De Empleo

OPERATING THE UNIT
3. Warning: If batteries leak and come into contact with the skin or eyes, wash immediately with
copious amounts of water.
4. Batteries must be handled by an adult. Keep batteries out of the reach of children.
5. Only batteries of the same or equivalent type are recommended.
6. You can also use rechargeable batteries.
7. Remove exhausted batteries from the unit.
8. Dispose of batteries safety according to battery manufacturer's instructions.
9. Do not use batteries that are past their expiry date.

Using a mains adapter

The device can also be operated with a mains adapter. Make sure that the adapter is permitted
for use with medical products and meets the following technical requirements; output voltage:
6VDC, output current: 600mA, mains barrel connector: plus internal, external diameter 5.5mm
internal diameter 2.1mm. You can always purchase a tested mains adapter from Promed
Please note:
If a mains adapter and rechargeable batteries are used at the same time, the rechargeable
batteries will not be recharged. Rechargeable batteries must always be recharged in a separate
DE
charging device.
Please note:
EN
If, during a measurement, the electricity supply is interrupted or the battery status display (6) lights
up, then the measurement absolutely must be repeated.
Connection of the upper arm arm cuff
FR
In order to connect the upper arm arm cuff (G) to the device, insert the tube connecting piece (F)
into the tube connection (E). While doing this, do not use excessive force to insert the connecting
piece in the device.
IT

Setting mode

1. Setting the units of measurement to be used
ES
In order to set whether mmHg or kPa should be
displayed, press the "SET" button (B) and the following
display will appear. By pressing the save button
NL
"MEM" (C) you can switch between the units. You
can save your setting by pressing the "SET" button (B)
– Standard = mmHg.
RU
2. User setting mode
Next, "User 1" or "User 2" is displayed on the screen.
By pressing the save button "MEM" (C), you can
PL
choose between "User 1" and "User 2". By pressing the
"SET" button (B) again, you can save your setting. It is
possible to change the user before every measurement.
SE
To do this, press twice the "Set" button (B) and choose the user by pressing the save button
"MEM" (C). In order to leave the setting mode and to start the measurement, now press the
START/STOP button (A).
FI
22