Technical Data - JBL ProTemp b10 Manual De Instrucciones

Ocultar thumbs Ver también para ProTemp b10:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 27

Technical data:

Type
Heating capacity
(W)
Length of heating
cable (m)
Length of heating
cable (m)
For aquariums
Suction holders
Primary voltage (V
/ Hz)
Secondary voltage
(V)
Output (W)
Length of power
cord (m)
Installation:
PLEASE NOTE: Prior to doing any work on the connecting terminals of the transformer,
make sure to disconnect the power plug.
1. Clean the bottom panel of the aquarium from the inside (dust-free).
2. Lay the heating cable (5) in loops at an equal distance of approx. 8 – 10 cm on the bot-
tom panel by using the enclosed mounting suction cups (Fig. 3). Make sure the cables do
not crisscross or kink. Moisten the suction cups slightly beforehand for better adhesion.
Caution: The heating cables have a certain length of a cold, non-heating lead (3, Cold
cable, see Table) on both sides. The transition from the cold lead to the heating part is
identified by a marking (4) on the cable.
3. Bring the two cold leads (3) out of the aquarium.
4. b10, b20: Unscrew the cover (10) on the transformer, remove the cover and pull off the
strain relief (9).
5. Secure the two cold leads in the connecting terminals for the cold cable (8) of the trans-
former (2). Polarity as desired.
6. b10, b20: Replace the strain relief and screw the cover back on.
7. Mount the transformer (2) in a well-ventilated place that is safe from splashing water.
8. Pour the substrate into the aquarium (Fig. 4). The following set-up on the bottom of the
tank has proven successful: 1.5 – 4 cm of JBL AquaBasis plus, the substrate developed
specially for aquarium plants, as the bottom layer, directly on the heating cable. This
should then be covered with a 4 – 8 cm thick layer of JBL Manado.
9. After the plants have been planted and the tank filled with water, the transformer can be
connected to the mains.
ProTemp b10
ProTemp b20
Data for the 12 V heating cable
10W / 12V
3,60
2 x 1,80
60-80 cm
50-120 L
20 x
230-240 /
50-60
11,5
10-60
2,0
ProTemp b40
20W / 12V
40W / 12V
4,90
2 x 2,00
80-100 cm
100 – 150 cm
100-250 L
200-400 L
30 x
Transformer data
230-240 /
230-240 /
50-60
11,5
10-60
2,0
ProTemp b60
60W / 12V
7,00
2 x 2,20
2 x 2,50
>150 cm
300-600 L
30 x
230-240 /
50-60
50-60
12
60
1,5
DE
9,00
GB
FR
NL
40 x
IT
12
SE
60
ES
1,5
PT
PL
CZ
RU
RO
TR
GR
CN
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Protemp b20Protemp b40Protemp b60

Tabla de contenido