Milnor MWF27J8 Mantenimiento página 10

Table of Contents
2.2.1.2. Incorrect Configuration or Connection of Equipment
2.2.2. Equipment and Procedures That Can Prevent Damage
2.2.2.1. Use the Chemical Manifold Supplied.
2.2.2.2. Close the line.
2.2.2.3. Do not let a vacuum occur.
2.2.2.4. Flush the chemical tube with water.
2.2.2.5. Put the chemical tube fully below the machine inlet.
2.2.2.6. Prevent leaks.
Chapter 3. Routine Maintenance
3.1. Routine Maintenance-Rubber Spring-resting, 27Kg
Washer-extractor
3.1.1. How To Show the Maintenance On a Calendar
3.1.2. Maintenance Summary
3.1.3. How to Remove Contamination
3.1.4. Lubricant Identification and Procedures
3.1.4.1. Grease Gun Procedures
3.1.4.2. Procedures for Bearing Components Connected to a
Grease Plate
3.1.4.3. Procedures for Motors
PELLERIN MILNOR CORPORATION
Sections
(Document BIUUUM09)
6
Figures, Tables, and Supplements
Figure 2: Incorrect Configurations That
Let the Chemical Supply Go In the
Machine by a Siphon
Figure 3: Incorrect Configurations That
Let the Chemical Supply Go In the
Machine by Gravity
Figure 4: Examples of Manifolds for
Chemical Tubes. Your equipment can
look different.
Figure 5: A Configuration that Prevents
Flow in the Machine When the Pump
is Off (if the chemical tube and tank
have no pressure)
Table 1: Where to Put Marks On a
Calendar
Table 2: Guards and Related Components
Table 3: Filters, Screens, and Sensitive
Components
Table 4: Fluid Containers
Table 5: Components that Become Worn
Table 6: Bearings and Bushings. See Table
7 for Motors.
Table 7: Motor Grease Schedule. Use the
data in Section 3.1.4.3 to complete this
table.
Table 8: Mechanisms and Settings
Table 9: Contamination Types, Cleaning
Agents, and Procedures
Table 10: Lubricant Identification
Figure 6: Motor Grease Maintenance
Conditions
Table 11: Motor Grease Intervals and
Quantities. Use grease EM (Table 10)