Before Operation - distianert DH-8 Manual De Instrucciones

BEFORE OPERATION

Power supply
Batteries Installation
Open the camera by unlocking latch firstly. The battery compartment
is the right part of the camera. Open the protective cover of the battery
compartment and insert 4 x 1.5 V LR6/AA batteries into the battery
slots. Make sure to insert each battery with correct polarity (+ and -
end against the long spring of each battery slot). To increase the
operating time, you can use 8 x 1.5 V LR6/AA batteries. When using 4
batteries, they all should be installed in the top 4 slots or in the bottom
4 slots.
Note:
• NEVER INSTALL DIFFERENT TYPES OF BATTERIES or NEW
AND OLD BATTERIES in the product at the same time.
• Anytime you load or unload batteries, make sure that the camera is
OFF. If using external power source, do not remove internal batteries.
Using an External Power Source
Optionally, you can connect an external 6V DC power source to the
'DC In' jack at the bottom of the camera. The power connector is a
3.5x1.35 mm coaxial DC power plug with positive 'tip' (inside pin)
polarity. Leave internal batteries in the camera during use.