Whale SH2202 Instrucciones De Instalación Y Usuario página 10

xii. Where the open end of the exhaust flue terminates, three sides of the underfloor space must be
kept open and not obstructed, and not contain through-floor ventilation openings.
xiii. The Space Heater, its gas supply, ducting and flues must be inspected in accordance with national
regulations or if these do not exist, the manufacturer's recommendations. Whale advises that this
must be carried out at least once every year.
xiv. The Space Heater must not be used when the vehicle is in motion unless the Vehicle in Motion
Flues and Bracket are fitted. The Vehicle in Motion Kit is not standard and is available separately.
Please refer to the Vehicle in Motion Kit instruction for further fitting considerations or contact
Whale® Support for more information.
If installing under the floor of the vehicle, please skip Steps 2 and 3.
Step 2 Internal Installation - Cut Out Holes for Exhaust and Combustion Air Flues
Position the template on the floor where the Space Heater is to be mounted. Mark the position of the two holes for
the combustion air inlet and exhaust flues, then drill holes with a 51mm (2") minimum diameter hole saw.
Space Heater
Gas In
Push on the ends of the flues with the blue adaptor to the pipes on the underside of the Space Heater ensuring they
are fully pushed on, and secure with supplied hose clips.
Step 3 Internal Installation - Attach Space Heater to The Floor
From inside the vehicle, feed the exhaust and combustion air flues through the holes drilled on the floor. Locate the
Space Heater so that the flues are centralised in the holes. Attach the Space Heater to floor with 4 screws supplied
(No. 8 x ¾"), as per Figs. 12 & 13.
Cold Air Inlet
Hot Air Outlet
Combustion Air Inlet
Combustion Air Inlet Flue
Fig. 11 Attaching Flues
Exhaust Flue
Vehicle Floor
Fig. 12 Locating the Space Heater
10
Hot Air Outlet
Exhaust Flue Outlet
Space Heater
Gas In
Combustion Air Inlet Flue
Exhaust Flue