Maintenance; Trouble Shooting - Whale SH2202 Instrucciones De Instalación Y Usuario

Adjusting The Temperature: Use the temperature control buttons to adjust the temperature. Press ' + ' to increase
the temperature. Press ' - ' to decrease the temperature. The Space Heater will automatically turn itself on and off to
maintain the desired ambient temperature.
Note: The Control Panel incorporates a low temperature / frost protection setting. This can be activated by pressing
' - ' until the frost icon is illuminated.
Symbol
8.

MAINTENANCE

If the Space Heater has not been used for some time, dust may have settled inside the Space Heater and the
ducting. Run the Space Heater on the "Fan only" setting (if available) until it clears. The outside of the appliance
should not normally require cleaning. If it does, isolate the electrical supplies and wipe down with a soft, damp cloth
only. Do not use abrasive cleaners. Allow to fully dry before reconnecting the electrical supplies.
The Whale® Space Heater must be checked periodically by a Whale® Approved Service Centre / Technician, or
competent person, at least annually. This must be completed according to the practice in the country where it is used
and according to the Whale® instructions. Whale recommends annual testing of gas soundness and combustion by
an accredited LPG gas engineer. The appliance contains ESD sensitive components and therefore must only be
opened by a Whale® Approved Service Centre / Technician (contact Whale® Support).
9.

TROUBLE SHOOTING

The Space Heater is equipped with an electronic diagnostic system which will detect fault conditions ranging from
poor gas or d.c. supply to internal Space Heater malfunctions. In the unlikely event of a failure, the red LED on the
Control Panel will light.
Option 1 - Whale Space Heater Control Panel
In the unlikely event of a failure, the red LED on the Control Panel will flash a number of times, pause, and repeat
until switched off. Count the number of flashes and refer to the table on page 21.
Gas Lockouts
Gas lockouts must be cleared by turning the selector knob from "gas on" (flame) position to "off" position then back
to the "gas on" position. The complete sequence of switch movements must be completed within 2.5 seconds for a
lockout to be successfully cleared. If there is air in the gas line, e.g. after a gas bottle change, the Space Heater may
require several attempts before it lights. Lockouts can also be cleared by switching to the 'fan only' position and then
back to 'on' within this 2.5 second period.
Table 3: Control Panel Functions
Setting
OFF Space Heater will be off.
Space Heater will operate on gas. There will be a pre-purge time of
around 30 seconds before ignition. When the gas is lit, the green LED will
Gas
be illuminated. If the Space Heater fails to light for any reason, the red
LED will flash. Refer to Trouble Shooting Guide (Section 9).
Electric Low Space Heater will operate at LOW on electric setting.
Electric Medium Space Heater will operate at MEDIUM on electric setting.
Electric High Space Heater will operate at HIGH on electric setting.
Fan
Space Heater will operate on Fan Only Operation.
*Whale Space Heater Control Panel Only.
Frost Protection Frost Protection will activate.
*Whale Duo Control Panel Only.
Description
20