Cleaning And Maintenance; Troubleshooting - Klarstein Bern Manual De Instrucciones

CLEANING AND MAINTENANCE

Note: always disconnect the appliance at the supply outlet socket before
undertaking any cleaning.
• Except for periodic cleaning of dust, there are no specific requirements for care,
other than regular cleaning of the general appliance. A wipe with a dry cloth is
normally sufficient. DO NOT use abrasive cleaners as they can damage the finish.
• Make sure the heater outlet grille (located next to the switches) are kept clear
of dust, pet hair and other airborne household matter. These should be vacuum
cleaned periodically using a brush attachment.
• If in doubt consult a qualified electrician.
• Excluding fuses, use only genuine manufacturers spare parts available from your
supplier.
Important information on maintenance and repairs
• The device has a special fuse. If the fuse has to be replaced, have it replaced by a
specialist company with a fuse of the same type.
• This product has no user-serviceable parts. Do not attempt to repair this product
yourself. Only qualified service personnel should perform servicing!

TROUBLESHOOTING

Problem
Fire is not switching on.
Logs glow but flame effect
does not work.
Heater doesn't work,
but Power and Heater
switches / buttons are in
the „ON" position
Possible Cause and Suggested Solution
Ensure mains switch is on.
Replace the fuse in the plug.
Check to see if the spinning motor is working.
Turn all switches / buttons to the „OFF" position and
unplug the unit from the wall outlet for 10 minutes. After
10 minutes plug the unit back into wall outlet, and
operate as normally.
EN
49