Front Wheel Lock; Safety - BABYTREND TS43 C Serie Manual De Instrucciones

ASSEMBLY
• Upright and Reclined Position: Buckle
the footrest and headrest straps on the
rear of the seat. Pull the excess straps to
tighten the seat (Fig. 7b).
• Carriage Position: Make sure both
footrest and headrest straps are
loosened and extend the seat surround
fully (Fig. 7b).
REMOVABLE CANOPY
8) • To attach the removable canopy:
Snap the Canopy clips on the inside of
the toddler seat tubes. Zip the Canopy
to the seat frame (Fig. 8).
9) • To open the canopy: push forward
on the front edge of the canopy while
holding the rear of canopy in place
(Fig. 9).
• To fold the canopy: pull backwards on
the front edge (Fig. 9).
7
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
BRAKES
Fig. 7b
10)
Fig.8

FRONT WHEEL LOCK

11)
Fig. 9b
WARNING:
Always
set brakes when the stroller
is not being pushed so
that the stroller will not roll
away. NEVER leave stroller
unattended on a hill or incline
as the stroller may slide down
the hill.
• To engage brakes, apply downward
pressure to the brake lever located on
the rear axle. The stroller might have to
be required to be rolled back and forth to
fully engage the brake (Fig. 10). Check
that the stroller will not move once the
brakes are properly applied. The brake
indicator will be red when locked and
green when unlocked. To release, gently
lift up on the brake lever.
(if eqquipped)
• The front wheels are equipped with a
swivel locking device. Push the button
on each wheel down to engage the locks
and push upward to disengage the locks
(Fig. 11a). Press small button on the
side to remove the front wheel
(Fig. 11b).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

SAFETY

Fig. 10
Fig. 11a Fig. 11b
8