Infant Car Seat - BABYTREND TS42 A Serie Manual De Instrucciones

INFANT CAR SEAT

INFANT CAR SEAT ATTACHMENT
WITH CHILD TRAY INSERT
WARNING:
Failure to
follow these car seat attachment
instructions could result in
serious injury or death.
• Put the stroller seat in the full reclined
12)
position (Fig. 11a). Check that the
front child tray is firmly attached to the
stroller armrests. Install the Tray Insert.
If needed (Refer to Step 3).
• Position the infant car seat so that it
faces toward the rear of the stroller.
Place the car seat so that it is cradled
on the inside of the front tray. Ensure
the car seat stoppers are resting on
the tray (Fig. 12a). When the infant car
seat is seated firmly into place, strap
both short clips over the infant car seat
through the seat belt slots on the infant
car seat and pull the strap adjuster
tight (Fig. 12b).
• Store the support strap located on the
back side of the stroller seat frame in
the side storage pocket (Fig 12c).
NOTE: It is very important that the
short clips are always tightly fastened
around the infant car seat. Always
secure your child with the car seat
harness when using the car seat in
the stroller. If your child is already in
the car seat, check that the child is
secured with the harness. Improper
use of the stroller with the car seat may
result in serious injury or death
11
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 12a
Pull
Fig. 12b
.
Fig. 12c
• To remove the Infant Car Seat, remove
both short clips from the seat belt slots
of the infant car seat (Fig. 12b). Pull
the Infant car seat upwards (Fig. 12d).
NOTE: When not using the car seat,
always store all straps and short clip
/ short clips into the storage pocket
attached to the side of the seat
(Fig. 12e).
Pull
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
Fig. 12d
Storage Pocket
Fig. 12e
12