Transmitter Set-Up (Australia And New Zealand); Prepare The Receiver Collar; To Insert And Remove The Battery - Petsafe stubborn dog in-ground fence Manual De Adiestramiento Y Funcionamiento

Transmitter Set-up (Australia and New Zealand)

1. Run the Boundary Wire through a window, under a door, through a crawl space vent, or any other
appropriate available access. you can also drill a hole through your wall.
2. Strip ⁄ inch of insulation from the ends of the Boundary Wire.
3
8
3. Press the red tabs on the Fence Transmitter and insert the twisted wire into the Boundary Wire Terminals.
Make sure wires do not touch each other at the terminals.
4. Turn the Boundary Width Control Knob to 10. This will set the Boundary Width at the maximum width.
5. Plug Power Adapter into Power Jack and AC Power Outlet.
6. The Power Light and Loop Indicator Lights should come on. If this does not happen see the
"Troubleshooting" section.
WARNING
CAUTION
NOTICE
Step

Prepare the Receiver Collar

5
Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points
for pets with long or thick hair. Tighten the Contact Points using Test Light Tool (5A) one-half
turn beyond finger tight. Check the tightness weekly.

To Insert and Remove the Battery

Note: Do not install the battery while the Receiver Collar is on your pet.
1. Remove the screws with a Phillips screwdriver.
2. Remove the Battery Lid (5B).
3. Install a 9-volt alkaline battery (5C).
4. Replace the Battery Lid (5C).
5. Reinstall the screws. Do not over-tighten the screws.
If the Receiver Indicator Light is flashing every 4 to 5 seconds,
battery replacement is required. Remove the old battery from
the Receiver Collar. Discharge all power by holding the correction
level button down until the light is no longer illuminated. Replace
with a new battery.
A replacement PetSafe
found at many retailers. Contact the Customer Care Center or visit our
web site at www.petsafe.net to locate a retailer near you.
12
• Do not install, connect, or remove your system during a lightning storm. If the storm is close enough for you to hear thunder,
it is close enough to create hazardous surges.
• Risk of electric shock. Use the Fence Transmitter indoors in dry location only.
If possible, DO NOT use an AC circuit protected with a Ground Fault Circuit Interrupter (GFCI) or Residual Current Device (RCD).
In rare cases, nearby lightning strikes may cause the GFCI or RCD to trip. Without power your dog may be vulnerable to escape.
You will have to reset the GFCI or RCD to restore power to the system.
For added protection, when unused for long periods of time or prior to thunderstorms, unplug from the wall outlet and
disconnect the loop boundary wires. This will prevent damage to the transmitter due to surges.
9-volt alkaline battery (PAC11-12067) can be
®
1-800-732-2677
5A
5B 5C